Microchip Technology Tariff Inquiry

AT90CAN128-15AT1

The AT90CAN128-15AT1 is a microcontroller unit (MCU) developed by Microchip Technology. It is based on the AT90CAN128 design and features an ATmega128-compatible core with a 16 MHz maximum operating frequency. Here's a brief description, features, and applications of the AT90CAN128-15AT1:

Description:

The AT90CAN128-15AT1 is a high-performance 8-bit AVR microcontroller with a built-in CAN interface. It is designed for applications requiring a combination of high computational power, real-time control, and communication capabilities. The device is housed in a 144-pin TQFP (Thin Quad Flat Package) package.

Features:

1. 8-bit AVR RISC-based core with 16 MHz maximum operating frequency.
2. 128KB In-System Programmable (ISP) Flash memory with boot code in System RAM.
3. 4KB EEPROM.
4. 16KB SRAM.
5. Built-in CAN (Controller Area Network) interface for communication.
6. 49 general-purpose I/O lines.
7. 2 UARTs (USARTs) with mode selection for SPI, USART, and LIN (Local Interconnect Network).
8. 2 10-bit ADCs with up to 24 channels.
9. 6-channel 8-bit PWM.
10. 2 16-bit Timer/Counters with PWM and Input Capture.
11. 2 8-bit Timer/Counters.
12. 2 Power Reduction Modes (Idle and Power-down).
13. On-chip debugging and programming support with JTAG and SPI interface.
14. Brownout detection and reset.
15. Programmable watchdog timer.

Applications:

The AT90CAN128-15AT1 is suitable for a wide range of applications that require a combination of computational power, real-time control, and communication capabilities. Some of the potential applications include:

1. Automotive control systems, such as engine management, body control, and safety systems.
2. Industrial automation and control systems, including motor control, robotics, and process control.
3. Medical equipment, such as monitoring devices, diagnostic equipment, and portable medical devices.
4. Networking and communication devices, including routers, modems, and IoT devices.
5. Consumer electronics, such as home automation systems, smart appliances, and portable devices.
6. Renewable energy systems, like solar panel monitoring and control systems.

The AT90CAN128-15AT1's built-in CAN interface makes it particularly well-suited for applications that require reliable and efficient communication between various electronic control units (ECUs) or nodes within a network.